云母钛珠光颜料的应用研究

介绍了一种不使用有机溶剂获得云母钛珠光颜料、水性金属效果云母钛珠光浆、珠光涂料的环保型制备工艺和性能.采用液相沉积法获得了不同厚度的纳米TiO2薄膜包覆层而显示银白、金、红、紫、蓝、绿等各种色彩的系列珠光云母颜料;应用珠光云母颜料与分散剂等水性助剂混合,获得了水性金属效果云母钛珠光浆的制备工艺;应用云母钛珠光浆与乳液配合,获得了云母钛珠光涂料的制备工艺.制备的云母钛珠光涂料系列多彩,白度高、反射率大、珠光效果好,硬度、附着力、耐候性等指标优异.     

焙烧温度对铁覆膜砂IOCS吸附Cr(VI)的影响

采用序批试验研究了焙烧温度对铁覆膜砂(Iron Oxide Coated Sand,IOGS)吸附6价铬Cr(VI)的吸附平衡和吸附速率的影响.结果表明,铬在IOCS上的吸附平衡符合Langmuir吸附模型.低温制备IOCS具有较高吸附容量且对pH不敏感.110℃制备IOGS在pH 7的最大吸附容量(0.181 mg·g-1)远高于660℃制备10CS(0.023 m8·8-1).吸附过程符合准二级动力学模型.吸附速率随焙烧温度提高而下降.     

船舶涂料海洋大气暴露与室内加速试验模拟性研究

通过两年海洋大气环境暴露试验、盐雾／紫外冷凝老化交替试验和氙灯老化试验。对比聚氨酯涂料、丙烯酸涂料涂层的色差和失光率，研究了3种试验对涂层表观性能的影响。发现紫外／冷凝老化加速试验对海洋大气暴露试验有很好的模拟性。     

太阳热反射涂料的研制

根据涂料反射太阳热的原理,以丙烯酸树脂为基料,以金红石型钛白粉、云母粉及空心玻璃微珠为原料,制备了隔热性能和耐候性能均良好的太阳热反射隔热涂料,并研究了颜料、填料种类、粒径、涂层厚度对涂料隔热性能的影响。     

Water vapor permeability of biodegradable polymers

The water vapor transmission rates (WVTR) of several biodegradable polymers were evaluated to determine their suitability as water-resistant coatings and to understand WVTR better in terms of polymer structure. Values of WVTR at 25‡C ranged from 13 to 2900 g/m² /day and increased in the order PHBV PLA (cryst.) PLA (amorph.) PCL Bionolle BAK 1095 CAP CA. Values of WVTR were positively correlated with higher polymer solubility parameters, lower crystallinities, and higher free volumes. Although the WVTR of biodegradable polymers are much higher than those of good barrier materials such as low-density polyethylene, they are sufficient for short-term (hours to days) protection of polysaccharide-based materials against water. Product names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by the USDA implies no approval of the product to the exclusion of others that may also be suitable.     

ZJR型涂料的制备及特性研究

利用溶胶凝胶法制备TiO2光催化剂,使用磷酸氢二钠、十水合四硼酸钠和氢氧化镁等制备了阻燃体系料,复合后制成ZJR涂料。利用热分析仪分析纳米TiO2和阻燃体系复合的防火涂料的温度与热失率关系,并得到热重与微商热重曲线。550~650℃之间,失重率约为11%,ZJR涂料在400~600℃有较好的阻燃效果。该涂料对污染气体的光催化降解研究结果表明:光照60 m in后,对二氧化硫的降解率为90.40%,紫外光照40 m in后,甲醛气体降解率为68.98%。进一步添加聚乙二醇和银离子使涂料改性,使涂料光催化甲醛的活性分别提高了11%和14%,效果显著。     

军绿有机涂层和金属漆涂层全浸泡下的腐蚀行为对比研究

目的针对车辆装备长期在高盐雾、高湿热、高日照等恶劣的气候环境下使用,会受到腐蚀影响的现状,探究现役军用有机涂层防护性能。方法采用电化学阻抗谱技术研究军绿有机涂层和金属漆涂层在3.5%NaCl溶液中的腐蚀电化学行为,分析这两种涂层在浸泡期间的电化学阻抗谱特征,通过拟合等效电路得到涂层电阻R_c和涂层电容C_c,并用这两个电化学参数评价军绿有机涂层和金属漆涂层的耐蚀性能。结果军绿有机涂层抗腐蚀介质渗透能力很强,而金属漆涂层抗腐蚀介质渗透能力稍弱。结论两种涂层都表现出很好的防护性能,且金属漆涂层在腐蚀后期的防护性能要优于军绿有机涂层。     

军绿有机涂层破损腐蚀行为研究

目的研究不同破损程度下军绿有机涂层的腐蚀行为,确定破损率对其防护性能变化的影响。方法通过人工制作不同的破损率,并利用电化学阻抗谱技术,研究不同破损程度下军绿有机涂层的电化学特征。结果根据不同破损程度下的军绿有机涂层的电化学特征,确定了涂层从完好到失效的四个阶段,初始完好阶段(破损率K≤0.0004%)、破损增大阶段(0.0016%K≤0.04%)、破损过大阶段(0.16%K≤1%)和失效阶段(4%K≤16%)。结论破损率K为0.04%的点是该涂层防护性能急转直下的转折点,因此破损率K大于0.04%时,应及时对车辆表面涂层进行修补和防护。     

Non-UV based germicidal activity of metal-doped TiO2 coating on solid surfaces

A stain-based screening method was developed to screen different catalyst coatings for their germicidal activity. A Baclight dead/live bacteria viability kit （invitrogen, molecular probes） was used for staining the cell. The screening was carried out following a standard procedure. This included loading cell suspension to solid surface and maintaining contact for 30 min, then staining with a mixture containing dyes. The stained cells were observed using an epifluorescent microscope and photographed with a CCD camera under UV. Metal-doped TiO2 coatings on AI plates were prepared and tested for non-UV germicidal activity without using UV. It was tested using model microorganisms such as Bakers Yeast （Saccharomyces cerevisiae）, Bacillus subtilis, Pseudomonas putida, and Escherichia coli. On the basis of the germicidal activity of catalyst and the degree of damage caused to the cells, the stained cells may appear green （viable）, green with red or yellow nuclei and yellow （compromised） or red （nonviable）. According to their stained color, cells were counted to calculate the percentage of dead, live, and compromised cells. Compromised cells are cells that grow very slowly after reculturing indicating a degree of reversible cell damage. Screening the germicidal activity using this staining method is accurate and efficient, and requires less time than the culture-based method. A modification to the procedure for measuring germicidal activity of rough surfaces or fibrous coatings was developed. Both TiO2 and metal-doped TiO2 （Ag, Pt, Au, Cu） possess non-UV based germicidal activity. The germicidal activity of TiO2 was found to be related with its wetting property and can be improved by UV irradiation before testing. It is not greatly affected by contact time, indicating a fast acting germicidal activity.     

天津市夏季蜂窝状溶蚀器涂层溶液浓度确定的实验研究

于2013年7月1日～8月31日,在天津市南开大学理化楼楼顶,采用蜂窝状溶蚀器进行了溶蚀器涂层溶液最适浓度的探究实验.结果表明,在天津夏季,蜂窝状溶蚀器的碳酸钠涂层溶液最适浓度为3%,柠檬酸涂层溶液最适浓度为6%.含有溶蚀器系统的颗粒物采样法与传统采样法对比发现,含蜂窝状溶蚀器的采样系统所得到的PM2.5样品浓度有86%低于传统方法所得到的PM2.5样品浓度,其原因主要为1酸/碱性气体被去除,使其无法与富集在采样膜上的颗粒物发生反应,也无法吸附到颗粒物上;2溶蚀器系统采样过程中,部分颗粒物被捕集到溶蚀器上;3酸/碱性气体被去除,导致气-粒平衡被打破,部分颗粒物组分向气态转化.